Rubber Hose Cover Abrasion Resistance Tester Material Hydraulic Hose Testing Machine

JGM-51 Rubber Hose Cover Abrasion Resistance Tester Material Abrasion Testing Machine

Abrasion Resistance Tester Product Introduction

The JGM-51 Rubber Hose Outer Cover Abrasion Tester is a special testing equipment designed for the rubber hose industry. It is used to determine the abrasion resistance of the outer cover of rubber hoses. By simulating the friction conditions in actual use, it accurately tests the mass loss of the sample, so as to evaluate the abrasion resistance and service life of the hose outer cover. It is a core instrument for hose manufacturers, quality inspection institutions and scientific research laboratories to control product quality.

Abrasion Resistance Tester Product Advantages

Specialized Design: Customized test structure for rubber hose outer cover, fully complying with industry test standards, accurate and reliable test results
Automatic Testing: Automatically runs after setting the friction times, and automatically stops when reaching the set times, no manual attendance required, improving test efficiency
Easy Operation: Simple structure design, convenient sample clamping, standardized test process, reducing manual operation errors
Stable and Durable: Adopts high-quality steel and wear-resistant parts, stable equipment operation, low failure rate, suitable for continuous testing in factories
Accurate Data: Cooperates with precision balance for mass loss calculation, good repeatability of test results, providing reliable basis for product quality control

Abrasion Resistance Tester Operating Procedure

Equipment Preparation: Place the equipment status identification card in the "running" state and connect the equipment power supply
Sample Preparation: Cut a 150mm long hose sample, remove surface dust, weigh and record the original mass with a precision balance
Clamping and Testing: Install the hose on the mandrel, fix it to the testing machine fixture, set the friction times, press the "Run" button to start the test, and the equipment will stop automatically
Data Calculation: Remove the sample, remove the outer cover particles, weigh the mass again, and the mass difference between the two times is the abrasion mass loss
Shutdown Process: After the test is completed, exit the program and turn off the host power supply

Quality Control

Certificate

Related Product

Material Support